Ocean Controls
PO Box 2191
Seaford BC
Factory 3/24Wise Ave
Seaford,
Vic, Australia 3198
ABN 22 061 932 027
Ph 61 3 9782 5882
Fax 61 3 9782 5517
Email Us
• Catalogue
• Shopping Cart
• Ordering Info
• Specials
• What's New
• Home
• Audio
• Communications
• Computer
Products
• Controllers
• Counters
Timers
• Data
Acquisition
• Data Loggers
• Micro
Programmers
• Modbus Products
• Moscad RTU
• Motor
Controllers
• Motors
• Panel Meters
• PLC's
• Power
Supplies
• Relays
• Sensors
• Signal Conditioners
• Software Commercial
• Software
Industrial
• Test Equipment
|
Infra Red Remote Controller Boards
|
KIT-058 Infra Red Relay Controller
This kit allows you to turn on and off a variety of electrical devices using almost any
household infrared remote control unit (e.g. TV, video, satellite, hi-fi, etc). Relay
output rated at 12VDC 5A or 240VAC 3A. If you wish to switch heavier loads use our DIN
mounted relays
Push any button of the remote control and the PCB mounted relay will turn on. Push any
button a few seconds or hours later and the relay will toggle off.
Relay Datasheet).
Supply: 8 - 15V DC required
PCB measures: 28x74mm.
Download datasheet file
|
Purchase |
KIT-142 Infra Red 12 Channel Relay
Board Controller
This kit comprises a commercial 14-button IR remote controller PLUS a
12 channel relay board. All 12 relays are provided on the receiver board - nothing more to
add. Makes it very simple to add infrared remote control to any project or existing
equipment.
Indicator LEDs show which relay is operated. Operating range up to 18 metres/60 feet
(length of the factory!).
The 12 relays are grouped into 2 groups of 8 and 4. Each group of relays can be set to
operate as toggling or momentary. Buttons 1 to 12 on the remote control operate the
corresponding relay on the receiver board, ie. button 1 operates relay 1, etc. Buttons 13
and 14 are used to turn off each group of relays.
The relay contacts are rated at 10A max. However the PCB traces will only handle about 5A
- additional heavy duty wire will need to be soldered from the relay contact to the screw
terminal connector to handle the full 10 amps. The relay outputs are also rated to switch
up to 240VAC mains voltages. Extreme care should be taken when switching mains voltage.
Don't do this unless you are experienced and know exactly what you are doing. Mains
voltages can be lethal!
Receiver board requires a 12VDC 500mA power supply - a suitable AC/DC adaptor will do
fine. The remote control unit requires 2 x AAA batteries (not supplied). The receiver
board measures 122mm x 113mm (4.8" x 4.45").
Download datasheet file
|
Purchase |
PURCHASING THE CONTROLLERS
All prices are in Australian Dollars. Prices do not include GST (Goods and
Services Tax). 10% GST applies to goods delivered in Australia. Australian GST is not paid
on shipments despatched to an international destination. You can check the exchange rate
by going to http://www.x-rates.com
Please note the 12VDC plug pack is only suitable for use in Australia and New
Zealand
|
 |
|
|
|
|
|
|
|
|
|
|