Ocean
Controls
PO Box 2191
Seaford BC
Factory 3/24Wise Ave
Seaford,
Vic, Australia 3198
ABN 22 061 932 027
Ph 61 3 9782 5882
Fax 61 3 9782 5517
Email Us
• Catalogue
• Shopping Cart
• Distributors
• Ordering Info
• Specials
• What's
New
• Home
• Audio
• Communications
• Computer
Products
• Controllers
• Counters Timers
• Data Acquisition
• Data Loggers
• Electrical
Parts
• Micro
Programmers
• Modbus Products
• Moscad RTU
• Motor
Controllers
• Motors
• Panel Meters
• PLC's
• Power Supplies
• Relays
• Sensors
• Signal
Conditioners
• Software
• Software
Industrial
• Test Equipment
• Tools
|
UHF
Remote Controllers |
UHF-001 2 Channel UHF Relay
Controller Module
Features 2
Relays rated to 2A at 24V DC and an NPN Transistor Output.
Each Relay can be set to operate in 2 second momentary mode or ON-OFF
latching mode.
Pushing both buttons together operates the Transistor Output.
Alternatively the Module can be put into 'Gate Opening' or 'Garage
Door' mode. In this mode each relay operates for 2 minutes when the
corresponding button is pushed. Pushing any button on the remote while
either of the relays are on when in this mode will switch the relays
off.
Operates on 12-24V DC or 15V AC.
30m Outdoor Range.
Supplied with one remote and is housed in an Attractive case with a
Microswitch Tamper Output for Alarm Systems if the cover is removed.
Dimensions 73 x 100 x 25mm, Antenna Protrudes 86mm.
Download User Manual
|
Purchase |
UHF-002 1
Channel UHF Relay Controller Module
This mains powered unit can switch 240V AC at 6 Amps via its inbuilt
relay. Up to 10 remotes can be taught to control the unit. The receiver
can operate in 4 modes, On/Off, Latched, Momentary and 2 minute Timed
operation. On/Off: The contacts are switched alternately. Latched: The
contacts are switched. Momentary: The button must be held down for 1
seconds to operate the relay for 1 second. 2 Minute Timed Output: The
button must be held down for 2 seconds to operate the relay for 2
minutes.
Operates on 240VAC
30m Outdoor Range.
Supplied with one remote and is housed in an Attractive case with a
Microswitch Tamper Output for Alarm Systems if the cover is removed.
Dimensions 73 x 100 x 25mm, Antenna Protrudes 86mm.
Download
User Manual
|
Purchase
|
UHF-010 Remote Controlled Mains Outlets
Allows remote control of just about any appliance in the home! This 8
channel mains switching package is suitable for switching up to 1000W.
This makes it perfect for automating devices around the home at the
touch of a button. Extra mains switches are available allowing up to 8
mains outlets to be controlled remotely. The RF signal used means you
don't even need to be in line-of-sight to the outlet unlike some
infra-red models available on the market. Please check power
consumption of your appliances before making your purchase
|
Purchase
|
UHF-011
Additional UHF Mains Outlets
These are an Additonal Mains
Outlet for the UHF-011 Remote control as shown above
Maximum switching power: 1000W
Transmission frequency: 433.92MHz
Operating range: 20m
|
Purchase |
PURCHASING THE UHF CONTROLLERS
All
prices are in Australian Dollars. Prices do not include GST (Goods and
Services Tax). 10% GST applies to goods delivered in Australia.
Australian GST is not paid on shipments despatched to an international
destination. You can check the exchange rate by going to http://www.x-rates.com
Please note the these
items are only suitable for use in Australia and New
Zealand
|
 |
|
|
|
|
|
|
|
|
|
|