The
LogBox-AA is an electronic data logger with two
universal analog input
channels. Input data is stored in the logger internal memory, for later
download to a PC for visualization and analysis in the form of tables or
graphs. The data is easily exported to spreadsheets.
The LogChart-II is the software used to configure the logger, download
and visualize data. The logger configuration allows defining the logger
operation mode, including programming the start/stop time of data
acquisition. Other parameters such as signal input type, logging
interval, etc, are easily selected through the LogChart-II software.
The LogBox-AA also provides a signal for commanding an external power
supply (battery) of a device connected to the logger. This feature
allows that external devices, such as a transmitter, be powered only
during the measurement sample time, thus extending the autonomy of these
external batteries..
|
 |
Features
Input: 0-20mA, 4-20mA, 0-50mV and 0-10Vdc,
J range: -50 to 760 °C (-58
to 1400ºF)
K range: -90 to 1370 °C
(-130 to 2498ºF)
T range: -100 to 400 °C
(-148 to 752ºF)
N range: -90 to 1300 °C
(-130 to 2372ºF)
R range: 0 to 1760 °C (32
to 3200ºF)
S range: 0 to 1760 °C (32
to 3200ºF)
B range: 150 to 1820 °C (32
to 3308ºF)
Pt100 range: -200.0 to
650.0 °C (-328 to 1202ºF)
Memory capacity: 32k readings If 2 channels are
configured each channel has 16K readings. If 1 channels
is configured it has the total memory of 32K readings
Interval between readings: 10 seconds to 18 hours
External battery switch time: 0 to 10 s
Power: Internal 3.6V lithium battery (1/2 AA)
Estimated autonomy: Over 2000 days (one daily download)
Working temperature: From –40°C to 70°C.
Protection: IP65
Material: ABC + PC case, Polycarbonate film;
Dimensions: 60x70x35mm:
Battery Switch
The LogBox has an external battery switch which
automatically switches on external power to sensors when taking a
reading, then switches power off again, thus extending external sensor
battery life.
Logchart Software
The configuration of
the
LogBox is done by the included LogChart
software. Data is transmitted to the LogBox through an Infrared wand
connected to the PC's USB port. The Parameter Configuration window in
LogChart lets you configure the following parameters:
Logging session title
Channel setup - name, type,
limits, scaling
start log options - immediatley
or timed
log rate
logging options - stop when full,
set number of readings
or roll-over
After the logging session is complete, data can then be downloaded again
by LogChart and displayed in table and chart formats. Data files can
then be saved as ASCII text files for importation into common
Spreadsheets. It is also possible to monitor
data in real-time.
Download
the Operating Manual
Purchasing the
LogBox
All prices are in Australian Dollars. Prices
do not include GST (Goods and Services Tax). 10% GST applies to goods delivered in
Australia. Australian GST is not paid on shipments despatched to an international
destination. You can check the exchange rate by going
to http://www.x-rates.com
|
