|
INTRODUCTION
Logbox-RHT
is a dual channel data
logger with buit-in temperature and relative
humidity sensors. Uses a high quality,
industrial grade humidity sensor, for accurate
and reliable operation in applications such as
transportation, storage of goods, process auditing and
others.
Can be easily programmed and set via a handy infrared
IR-LINK
3 interface
connected to a USB port under Windows software
or with a Palm compatible PDA IrDA interface
under PalmOS.
LogChart II
software allows for logger configuration,
recorded data retrieval, plotting, historical
analysis and exports data to spread sheets.
Its sturdy water proof enclosure provides full
performance in the most demanding applications.
Purchase
Download
the Operating Manual
|
 |
Features
-
Temperature measurement
- Range: -40 to 80 °C. Resolution: 0.1°C
- Response time:up to 30 s in fairly still air
- Humidity measurement
- RH Range: 0 to 100 %RH. Resolution: 0.1 %RH
- Dew point range: -40 ° to 100 °C. Resolution
0.1 °C
- Response time: 4s in fairly still air, from
20 to 80 %RH
- Accuracy: See figure;
- Memory for 32,000 recordings in one channel
or 16,000 recordings for each channel;
- Recording interval: programmable from 1 s to
18 hours;
- Logger start: immediately, outset by the
device’s button,by date/hour or by a programmed setpoint;
- Logger stop: at full memory; at some
specified date and hour, number of samples or never (circular memory);
- Infrared communication range: 1 meter, 30°
angle;
- Internal replaceable lithium cell (3.6V 1/2
AA);
- Estimated battery life: 2 years with one
daily download. Battery life depends heavily on data retrieval frequency;
- Configuration and data retrieval software
for Windows 98, XP, 2000 and PalmOS;
- Operating temperature: -40°C to 80°C;
- Enclosure: IP65 (electronics), IP40 (sensor
probe), flame retardant, ABS+PC;
- Dimensions: 70x60x35
Logchart Software
The configuration of
the
LogBox is done by the included LogChart
software. Data is transmitted to the LogBox through an Infrared wand
connected to the PC's USB port. The Parameter Configuration window in
LogChart lets you configure the following parameters:
Logging session title
Channel setup - name, type,
limits, scaling
start log options - immediately
or timed
log rate
logging options - stop when full,
set number of readings
or roll-over
After the logging session is complete, data can then be downloaded again
by LogChart and displayed in table and chart formats. Data files can
then be saved as ASCII text files for importation into common
Spreadsheets. It is also possible to monitor
data in real-time.
Purchasing the
LogBox
All prices are in Australian Dollars. Prices
do not include GST (Goods and Services Tax). 10% GST applies to goods delivered in
Australia. Australian GST is not paid on shipments despatched to an international
destination. You can check the exchange rate by going
to http://www.x-rates.com
|
