KTA250 Anemometer Interface Card

Ocean Controls
PO Box 2191
Seaford BC
Factory 3/24Wise Ave
Seaford,
Vic, Australia 3198
ABN 22 061 932 027

Ph 61 3 9782 5882
Fax 61 3 9782 5517

Email Us

• Catalogue
• Shopping Cart
• Ordering Info
• Specials
• What's New
• Home
• Audio
• Communications
• Computer Products
• Controllers
• Counters Timers
• Data Acquisition
• Data Loggers
• Micro Programmers
• Modbus Products
• Moscad RTU
• Motor Controllers
• Motors
• Panel Meters
• PLC's
• Power Supplies
• Relays
• Sensors
• Signal Conditioners
• Software Commercial
• Software Industrial
• Test Equipment

Anemometer Interface Card

Do you want to connect your PLC, RTU or SCADA System to a Davis Instruments Anemometer

Interface From Only AUD$159
Annemometer Only AUD$185

Order Online

The KTA-250 is an anemometer monitoring and alarming card. It allows the wind speed and direction to be measured with a Davis Instruments DS7911 Anemometer, without the need for the entire weather station. Monitoring of the wind speed and direction can be done via the analog retransmission channels with 0-5V, 1-5V, 0-20mA or 4-20mA outputs. As well as monitoring the speed and direction, 2 alarm relays can be programmed to activate at a certain speed or wind direction range, or combination of the two. Wind speed and direction can also be monitored using the Modbus protocol with either an RS232 or 2-wire RS485 connection. All settings are set using the Modbus protocol and the provided software.

Features Include
–      Connects to Davis Instruments DS7911 Anemometer
–       Monitor both the wind speed and direction
–       Interface to PLC's using the Modbus protocol
–       Communicate via RS232 or 2-wire RS485
–       Interface to PLC's/Instruments or other controllers using 4-20mA or 0-5V signals
–       Generate relay alarms depending on the wind speed and direction
–       Alarms can be monitored by the on board relays or via the Modbus protocol
–       DIN Rail mounting available

Software
We supply a software configuration package called "KTA-250 Configurator" which is a simple to use program. The configuration software allows the user to monitor the wind speed and direction, as well as the maximum and minimum speeds, and allows the user to set all the available settings.

Download the KTA-250 Interface Manual

Download the Annemometer Manual

Purchasing the KTA-250 ANEMOMETER INTERFACE CARD AND ANNEMOMETER

All prices are in Australian Dollars. Prices do not include GST (Goods and Services Tax). 10% GST applies to goods delivered in Australia. Australian GST is not paid on shipments despatched to an international destination. You can check the exchange rate by going to http://www.x-rates.com