Network Cable Tester and DVM

Ocean Controls
PO Box 2191
Seaford BC
Factory 3/24Wise Ave
Seaford,
Vic, Australia 3198
ABN 22 061 932 027

Ph 61 3 9782 5882
Fax 61 3 9782 5517

Email Us

• Catalogue
• Shopping Cart
• Distributors
• Ordering Info
• Specials
• What's New
• Home
• Audio
• Communications
• Computer Products
• Controllers
• Counters Timers
• Data Acquisition
• Data Loggers
• Electrical Parts
• Micro Programmers
• Modbus Products
• Moscad RTU
• Motor Controllers
• Motors
• Panel Meters
• PLC's
• Power Supplies
• Relays
• Sensors
• Signal Conditioners
• Software
• Software Industrial
• Test Equipment
• Tools

Network Cable Tester & DVM

Network Cable Tester and DVM
This is 2 instruments in one. It is ideal for network installers or technicians and will allow the user to easily check cable integrity or measure AC & DC voltage, current, resistance, and continuity etc. without needing to carry two separate devices. The unit will check for cable continuity, open-circuits, short-circuits, and cross-connects etc. A remote terminator is included and enables the user to check network cables at a wall jack or patch panel. Supplied with loop back cable, LAN terminator, and multimeter leads.

LAN tester specifications:
* LAN tester checks faults & miss wired conductors
* Manual or automatic testing

DMM Specifications:
* 600 volt max input
* 200mA AC/DC
* 20M ohm resistance
* 3.5 digit
* Diode test
* Data hold
* Max hold
.

PURCHASING

All prices are in Australian Dollars. Prices do not include GST (Goods and Services Tax). 10% GST applies to goods delivered in Australia. Australian GST is not paid on shipments despatched to an international destination. You can check the exchange rate by going to http://www.x-rates.com Please note our plug packs are suitable only for 240VAC mains (Not suitable for North America)